watch DVD about 'Nonmagnetic Stylus'

click here to contact us

Centering Gauge Swing Type is an ultra-high precision 3D touch sensor (probe) with higher quality than that of Point Finder series! Repeatability is guaranteed. All model has a buzzer with it. Repeatability is ±0.25μm!! *This is the designated product for the machining center made by Okuma Corp. If you use Okuma's machining center, please let us know its model.

Specifications

Centering Gauge Swing Type
Model Shank Included battery Model Shank Included battery
S-20NM φ20 1 lithium battery
[CR2]		 S-25NM φ25 1 lithium battery
[CR2]
S-32NM φ32 S-42NM φ42
NT-30NM NT30 BT-30NM BT30
NT-40NM NT40 BT-40NM BT40
NT-50NM NT50 BT-50NM BT50

Two single-ended wrenches [5.5mm/6mm] and 3 hex wrenches [1.5mm/2mm/2.5mm] are included.
It is possible to change the position of keyway on the flange section. Please feel free to contact us.
When you use Centering Gauge Swing Type for a machinining center made by Okuma Corp., let us know its model.

As a standard-sized stylus, ST-6×100N is equipped with Centering Gauge Swing Type.
It is possible to exchange the size of stylus. For details, refer to 【Nonmagnetic Stylus】

Using Centering Gauge Swying Type on a machining center with a ceramic bearing, it blocks electricity and a workpiece can't be measured. 'Magnet cable M-500' is a MUST! Length: 50cm It's easy to use: put a magnet on the housing(front cover) of CG Swing Type and the other one on a workpiece.

Dimensions

Dimensions of Centering Gauge Swing Type

print out the features, measuring method, specifications and dimensions of Centering Gauge Swing Type.