FAQ - Align the vernier use to sign vice in the mold parts processing has been accurately measured, but do not know the angle will out error

	Although we use a sign vice to process mold parts and accurately measure the vernier, an error comes out and the angle is not clearly understood.
	Adjust by using the vernier whether it is accurately measured by angle processing in the figure below, but do not know if the angle is wrong. Please refer to Q16. Please refer to this question for angle measurement.

	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]　　[Tool Setter Series] [Centering Gauge Swing Type]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-machine measurement